How to make spy gadgets

Instructions

1. • 1
     Use these instructions to make the video spy glasses. You will need: micro spy camera, chunky sunglasses, soldering gun, heat shrinking tubing, glue gun, wire strippers, camcorder, and 9v battery. Reveal the wires on the camera. Solder metal to each wire until it extends 3 feet. Install the mini camera inside the corner of the glasses. Use the shrinking tube to cover the wires. Attach the wires through your shirt to the camcorder. Charge the camera, using the battery.
   • 2
     Use these instructions to make a spy telescope. You will need: narrow cardboard box, duct tape, 2 small mirrors, x-acto knife, and marker. Seal the ends of the box with tape. Cover the whole box in tape. Lay a mirror on one side of the box. Outline the mirror and cut out shape. Cut out the mirror shape. Do the same thing on the opposite side of the box. Cut diagonal slots for the mirrors to sit in. Both mirrors should be at 45 degree angles to each other. You should be able to see one with the other. Slide the mirrors into the slots. Tape them in place.
   • 
     
   • 3
     Use these instructions to create a mechanical lock-pick. Use a computer mouse, hard drive, power supply, floppy disk, solder, and mini screwdrivers. Open up the computer's hard drive. Take out everything but the motor that spins the head. Use the metal from the floppy disk to attach a screwdriver to the vibrating part of the hard drive. Attach the hard drive to the power supply to see if it is working. Take the button switch from the mouse and solder to the power supply. This is how you will turn on the lockpick. Put the mouse back together. Attach it to the hard drive. When you press the mouse button, the screwdriver will vibrate. Doing this inside a lock will cause it to open.
   • 4
     Use these instructions to make a hollow book. Use glue, water, a hardback book, x-acto knife, box cutter, paint brush, pencil, ruler, and bowl. Glue all the pages together with 70% glue and 30% water. Mix this up in the bowl. Leave about 2 to 3 pages in the front that you don't glue. Let dry. Draw a ½-inch border along all sides of the pages and cut the hollow section out. Glue the pages that are inside together and let them dry. Make sure that the pages in the front are still loose.